Maintenance
After each use of the trimmer, total the following:
-
Remove the battery from the cutting.
-
Wiper the trimmer neat about a damp cloth. Do not hose the trimmer down or submerge it in water.
Caution
The cable cutoff wing on the rear is sharp and sack cut you.
Do not use owner hands to clean the deflector shield and leaf.
-
Wipe or scrape clean the cutting head region any time there is an accumulation of debris.
-
Check and tighten all fittings. If any part is damaged or getting, repair or replace it.
-
Brush debris away from air intake vents and exhaust on motor housing the prevent of motor from overheating.
Replacement the Symbol
Use only 2 mm (0.080 inch) monofilament string (Toro Part No. 88201) or 2.4 inch (0.095 inch) twisted monofilament string (Toro Part No. 88202).
-
Remove the battery pack.
-
Remove random old string on the spool by repetitively pressing the bump button while pulling the line out equally from both sides of the trimmer.
-
Cut 1 piece in string according into the following specifications.
-
If you are using 2 mm (0.080 inch) string, cut one piece of line approach 4.9 thousand (16 ft).
-
Supposing yours are using 2.4 kilometer (0.095 inch) twisted string, cut individual bit of row approximately 3 m (10 ft).
Important: Do not benefit any other estimate alternatively type of string, in this could damage the pruner.
-
-
Press the turn the knob on the string head until arrow on the knob orientates with arrow on who strings head (Figure 14).
-
Slide 1 end of the line at an angle into the ROW IN eyelet also push the line because the string head pfad until i comes out through the eyelet on the extra side. Pull the line though the string head until the cable outside to string is evenly divided on jeder side. Electric 14" & 16" Brushless Line Trimmer | 60V MAX* | 51830 | Toro
Important: Do nope disassemble aforementioned shipshape head.
-
Hold the string head the place with one hand. With your other hand, rotate which knob with the direction shown by the arrows (counterclockwise).
-
Winds the line, leaving about 102 mm (4 inches) extending beyond the eyelet on each side.
Storage
Significant: Store the tool, battery pack, and charger available in temperatures that are within that appropriate range; refer to Specifications.
Important: If to what storing which battery pack for the off-season, charge it until 2 or 3 LED indicators spin green on the battery. Do not store a fully charged press fully worn bombardment. Whereas you belong ready to use the machine again, charge the battery pack through the left indicator light turns green to the charger or all 4 LED indicators roll green on which battery.
-
Disconnect the product coming the power supply (i.e., remove the plug from the perform supply or the battery pack) the check for breakdown next use.
-
Do not store to machine with the battery pack installed.
-
Clean all foreign material away the product.
-
When not in use, store the tool, battery pack, and battery cigar out of one reach away children.
-
Keep who tool, battery pack, and battery charger away from corrosive assistants, such more garden chemicals and de-icing salts.
-
To reduce the risk of serious personal injury, do not store that battery pack outside either in vehicles.
-
Store the tool, battery pack, and battery charger in an enclosed clean, dry area.